Sony HCD-CP11 Operating Instructions - Page 8

Step 3: Presetting radio stations (continued) To tune in a weak station In step 3, press TUNING MODE repeatedly until "AUTO" and "PRESET" disappear, then press TUNING +/- repeatedly to tune in the station. To change the preset number Start over from step 2. Tip The preset stations are saved in the system's memory for about two days even if you disconnect the power cord or a power failure occurs. To change the AM tuning interval (not applicable on the European and Middle Eastern models) The AM tuning interval is factory-preset to 9 kHz (or 10 kHz on North American model). To switch the AM tuning interval, tune in any AM station first, then turn off the system. Pressing TUNING + down, turn the system back on. When you change the interval, all the AM preset stations are erased. To change back to the original interval, tune in any AM station first, then turn off the system. Pressing TUNING - down, turn the system back on. Connecting optional components This section explains how to connect a variety of components to your system in order to enhance it. Refer to the instructions included with each component for details. Connecting audio components Connecting an MD deck for analog recording You can connect an MD deck to the system with commercially available audio cords. Be sure to match the color-coded pins to the appropriate jacks. To listen to the MD deck after connecting it, press MD/VIDEO until "MD" appears. To the audio input jacks on the MD deck To the audio output jacks on the MD deck 8