Sony HCD-XG500 Service Manual - Page 14
Function], Play°mode], Repeat], °°°°/clock°set], Enter/next], Disc°4], Aging Mode]
View all Sony HCD-XG500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
HCD-XG60/XG500 [Aging Mode] This mode can be used for operation check of tape deck section. Tape deck section work in parallel. • If an error occurred: The aging operation stops and display then status. • If no error occurs: The aging operation continues repeatedly. Procedure: 1. Load the tapes into the decks A and B respectively. 2. Press the [FUNCTION] button to select the function "CD". 3. Press the [PLAY MODE] button to set the "ALL DISCS" mode, and press the [REPEAT] button to "REPEAT" off. 4. Press three buttons of [ c /CLOCK SET], [ENTER/NEXT], and [DISC 4] simultaneously. 5. The aging mode is activated, if the indicator of disc tray num- ber on the fluorescent indicator tube is blinking. 6. To release from the aging mode, press the ?/1 button to turn the power OFF and operate the cold reset. (Refer to the "MC Cold Reset") 1. Display at the Aging Mode • Display operating state of tape deck section alternately. • If an error occurred, stop display. 2. Tape Deck Section • The sequence during the aging mode is following as below. • If an error occurred, stop display that step. Aging mode sequence (Tape deck section) : Rewind the tape A and B "TAPE A AG-1" Shut off FWD play the tape A "TAPE A AG-2" 2 minutes Fast forward the tape A "TAPE A AG-3" Shut off or 20 seconds REV play the tape A "TAPE A AG-4" 2 minutes Rewind the tape A "TAPE A AG-5" Shut off FWD play the tape B "TAPE B AG-2" 2 minutes Fast forward the tape B "TAPE B AG-3" Shut off or 20 seconds REV play the tape B "TAPE B AG-4" 2 minutes Rewind the tape B "TAPE B AG-5" Shut off Note: "TAPE * AG-*" is display of each step. 14