Sony HT-CT550W Operating Instructions - Page 39
Cancelling the Secure Link, function SECURE OFF - firmware
View all Sony HT-CT550W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Advanced Settings Note • When the receiver is turned off via the AUTO STBY function, the receiver may not be turned on automatically when you turn on the TV next time. Checking the version of the receiver (VERSION) The current firmware version information appears on the front panel display. Activating wireless transmission between specific units (SECURE ON) You can specify the wireless connection to be used to link the receiver to the subwoofer using the Secure Link function. This function is useful when you use multiple wireless products. 1 Select "WIRELESS" in the AMP menu, then press or c. 2 Select "SECURE ON," then press or c. 3 "START" appears, then press . "SEARCH" appears, and the receiver searches for equipment that can be used with Secure Link. Proceed to the next step within 2 minutes. To quit the Secure Link function during a search for equipment, press C. 4 Press SECURE LINK on the rear of the subwoofer with the point of a pen, etc. "COMPLETE" appears on the front panel display, and the LINK/STANDBY indicator on the subwoofer turns amber. If "FAILED" appears on the front panel display, check to ensure the subwoofer is turned on, and try to perform the process again from step 1. 5 Press AMP MENU. The AMP menu turns off. Cancelling the Secure Link function (SECURE OFF) 1 Select "WIRELESS" in the AMP menu, then press or c. 2 Select "SECURE OFF," then press or c. 3 "RELEASE" appears, then press . "COMPLETE" appears on the front panel display. 4 Press AMP MENU. The AMP menu turns off. 5 Press and hold SECURE LINK on the rear of the subwoofer for several seconds until the LINK/STANDBY indicator turns green or flashes in green. Be sure to press SECURE LINK with the point of a pen, etc. Setting the frequency for the wireless system (RF CHANNEL) If you use multiple wireless systems, such as a wireless LAN (Local Area Network) or Bluetooth, the wireless signals may be unstable. In this case, the transmission may be improved by changing the following RF Channel setting. • AUTO: Normally select this item. The system automatically selects the best channel for transmission. • 1: Set the frequency to CH1 (LOW 5.736 GHz). • 2: Set the frequency to CH2 (MID 5.762 GHz). • 3: Set the frequency to CH3 (HIGH 5.814 GHz). Note • The transmission may be improved by changing the transmission channel (frequency) of the other wireless system(s). For details, refer to the operating instructions of the other wireless system(s). continued 39US