Sony HT-DDW900 Operating Instructions - Page 71

Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U only) With 6 ohm loads, both channels driven, from 120 - 20,000 Hz; rated 90 watts per channel minimum RMS power, with no more than 0.7% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Power Output1) Models of area code U, CA (6 ohms 1 kHz, THD 0.7%) FRONT2): 90 W/ch CENTER2): 90 W SUR2): 90 W/ch (6 ohms 1 kHz, THD 10%) FRONT2): 140 W/ch CENTER2): 140 W SUR2): 140 W/ch 1)Measured under the following conditions: Area code Power requirements U, CA 120 V AC, 60 Hz 2)Depending on the sound field settings and the source, there may be no sound output. Inputs (Analog) MULTI CH IN, SA-CD/CD, MD/TAPE, DVD, VIDEO 1, 2, 3 Sensitivity: 800 mV Impedance: 50 kohms Inputs (Digital) DVD (Coaxial) VIDEO 1, 2 (Optical) Sensitivity: - Impedance: 75 ohms Sensitivity: - Impedance: - Outputs (Analog) MD/TAPE (OUT), VIDEO 1 (AUDIO OUT) SUB WOOFER Voltage: 800 mV Impedance: 10 kohms Voltage: 2 V Impedance: 1 kohm Reproduction frequency range 28 - 20,000 Hz Tone Gain levels ±6 dB, 1 dB step FM tuner section Tuning range 87.5 - 108.0 MHz Antenna FM wire antenna Antenna terminals 75 ohms, unbalanced Intermediate frequency 10.7 MHz AM tuner section Tuning range Models of area code U, CA With 10-kHz tuning scale: 530 - 1,710 kHz3) With 9-kHz tuning scale: 531 - 1,710 kHz3) Antenna Loop antenna Intermediate frequency 450 kHz 3)You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. While holding down TUNING MODE, press ?/1. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure. Video section Inputs/Outputs Video: 1 Vp-p, 75 ohms COMPONENT VIDEO: Y: 1 Vp-p, 75 ohms PB/CB/B-Y: 0.7 Vp-p, 75 ohms PR/CR/R-Y: 0.7 Vp-p, 75 ohms 80 MHz HD Pass Through continued 71US Additional Information