Sony HWSBTA2W Operating Instructions - Page 12
Pairing, Select HWS-BTA2W appeared on the display of the BLUETOOTH
UPC - 027242695054
View all Sony HWSBTA2W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Pairing Check the following before operating the unit. - The TX/RX switch is set to "RX." - This unit is connected to a power source and the 1 indicator (green) goes off. 1 Press and hold the ID SET button for 7 seconds or more. When the 1 indicator (green) and indicator (blue) start flashing together, release the button. This unit enters pairing mode. Note Pairing mode is canceled and this unit is turned off after about 5 minutes. If this unit is turned off while performing the procedure, start over from step 1. 2 Perform pairing procedure on the BLUETOOTH stereo audio source device to detect this unit. The list of detected devices appear on the display of the BLUETOOTH stereo audio source device. This unit is displayed as "HWS-BTA2W." If "HWS-BTA2W" is not displayed, repeat from step 1. Notes • When pairing, be sure to place both the BLUETOOTH devices within 1 m (3 ft) of each other. • Some devices cannot display the list of detected devices. 3 Select "HWS-BTA2W" appeared on the display of the BLUETOOTH stereo audio source device. 12 US