Sony KDL-37NL140 Operating Instructions - Page 8

Preparation for Wall-Mounting This TV can be installed on a wall by using a WallMount Bracket (sold separately). Before mounting the TV on a wall, the Table-Top Stand must be removed from the TV. ~ • Do not remove the Table-Top Stand for any reason other than to wall-mount the TV. • For product protection and safety reasons, Sony strongly recommends that you use the Wall-Mount Bracket model designed for your TV and the wallmounting of your TV should be performed by a Sony dealer or licensed contractor. Use your TV with the following WALL-MOUNT BRACKET. Sony Wall-Mount Bracket Model No. Sony TV Model No. KDL-26NL140 KDL-32NL140 KDL-37NL140 SU-WL100 SU-WL500 • For bracket installation, refer to the instructions on page 9 and the instruction guide provided by the WallMount Bracket model for your TV. Sufficient expertise is required in installing this TV, especially to determine the strength of the wall for withstanding the TV's weight. • Be sure to store the removed screws and the Table-Top Stand in a safe place until you are ready to reattach the Table-Top Stand. Keep the screws away from children. Follow the simple steps below to remove the TableTop Stand: 1 Disconnect all the cables from the TV. 2 Gently lay the TV (face down) onto a level and stable surface covered with a thick and soft cloth. Make sure the Table-Top Stand is hanging over the edge. 3 Remove the 4 screws from behind the TV as indicated below. Do not remove any other screws from the TV. 4 Secure the Mounting Hooks to the rear of the TV. For more details, refer to Installing the Wall-Mount Bracket and also the Instruction Guide provided by the Wall-Mount Bracket model for your TV. ~ • If an electric screwdriver is used, set the torque to tighten at approximately 1.5 N·m {15Kgf·cm}. 8