Sony KDL-40XBR6 Operating Instructions - Page 7
Preparation for Wall-Mount Bracket, When Installing the TV Against a Wall or Enclosed Area
UPC - 027242739130
View all Sony KDL-40XBR6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4 Use the supplied screws to attach the TV unit to the Table-Top Stand (refer to the "Attaching the Table-Top Stand" flyer). If an electric screwdriver is used, set AC IN the torque to tighten at approximately 1.5 N·m, 15 Kgf·cm. Preparation for Wall-Mount Bracket All models are ready to be mounted on a wall. • For product protection and safety reasons, Sony strongly recommends that you use the Wall-Mount Bracket model designed for your TV and the wall-mounting of your TV should be performed by a Sony dealer or licensed contractor. • Sufficient expertise is required in installing this TV, especially to determine the strength of the wall for withstanding the TV's weight. • Be sure to use the screws supplied with the WallMount Bracket when attaching the mounting hooks to the TV set. The supplied M6 screws are designed so that they are 8 mm to 12 mm in length when measured from the attaching surface of the mounting hook. The diameter and length of the screws differ depending on the Wall-Mount Bracket model. Use of screws other than those supplied may result in internal damage to the TV set or cause it to fall, etc. 8-12 mm M6 screw (supplied with the Wall-Mount Bracket) Mounting Hook Rear of the TV set • Be sure to store the unused screws and Table-Top Stand in a safe place until you are ready to attach the Table-Top Stand. Keep the screws away from small children. For details on how to use the Wall-Mount Bracket compatible with your model, visit www.sony.com/accessories Or call 1-800-488-7669 (for United States) 1-877-899-7669 (for Canada) When Installing the TV Against a Wall or Enclosed Area Make sure that your TV has adequate air circulation. Allow enough space around the TV as shown below. Avoid operating the TV at temperatures below 41 °F (5 °C). Installed with stand 11 7/8 inches (30 cm) 4 inches (10 cm) 4 inches (10 cm) 2 3/8 inches (6 cm) Leave at least this much space around the set. Installed on the wall 4 inches (10 cm) 11 7/8 inches (30 cm) 4 inches (10 cm) 4 inches (10 cm) Leave at least this much space around the set. Never install the TV set as follows: Air circulation is blocked. Air circulation is blocked. Wall Wall ~ • Inadequate air circulation can lead to overheating of the TV and may cause damage to your TV or cause a fire. Consider the following for best picture quality • Do not expose the screen to direct illumination or sunlight. • Use spot lighting directed down from the ceiling or cover the windows that face the screen with opaque drapery. • Install the TV in a room where the floor and walls are not of a reflective material. (Continued) 7 Getting Started