Sony KP-61V90 Operating Instructions - Page 53
Operating a Cable Box or Satellite Receiver (SAT), Setting the Manufacturer's Code
View all Sony KP-61V90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Operating a Cable Box or Satellite Receiver (SAT) Setting the Manufacturer's Code You can program the supplied remote control to operate a cable box or satellite receiver. Press CODE SET, SAT/CABLE (FUNCTION), and the 0-9 buttons to enter the manufacturer's code number (see the following chart), then press ENTER. For example, to operate a Sony satellite receiver: FUNCTION CODE SET SAT/CABLE 8 0 ENTER 1 Manufacturer code numbers (cable box) Manufacturer Code Hamlin/Regal Jerrold/G.I Oak Panasonic Pioneer Scientific Atlanta Tocom Zenith 222, 223, 224, 225, 226 201, 202, 203, 204, 205, 222, 206, 207, 208, 218 227, 228, 229 219, 220, 221 214, 215 209, 210, 211 216, 217 212, 213 Manufacturer code numbers (satellite receiver) Manufacturer Sony General Electric Hitachi Hughes Panasonic RCA/PROSCAN Toshiba Code number 801 (preset code for remote control) 802, 808 805 804 803 802 806, 807 To operate the cable box or satellite receiver (SAT) 1 Press SAT/CABLE (POWER) [Green Button] to turn on/off the cable box or satellite receiver. 2 Press SAT/CABLE (FUNCTION). 3 For other operations, refer to the operating instructions that come with the equipment. The GUIDE and INDEX (blue-labeled) buttons can be used only with a satellite receiver. If the remote control doesn't work • Try repeating the set up procedures using the other codes listed for your equipment. To operate the projection TV Press TV (FUNCTION). Then use the projection TV control buttons to control the projection TV. Tips z • If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment. • If you enter a new code number, the code number you previously entered at that setting is erased. • In some rare cases, you may not be able to operate your equipment with the supplied remote control. In this case, use the equipment's own remote control unit. • Whenever you remove the batteries - to replace them, for example - if too much time is taken, the code numbers may revert to the factory setting and must be reset. 49