Sony KV-1953RX Primary User Manual - Page 16
Viewing, Playback
View all Sony KV-1953RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
VIEWING VTR PLAYBACK To view the playback picture from a Sony Betamax videocassette recorder (or other VTR) equipped with an rf output terminal. CONNECTION VHF antenna UHF antenna Connect a suitable VHF and UHF or combination antenna to the recorder. TV Connect the rf output of the recorder to the VHF antenna terminal of the TV, and the UHF OUT terminals of the recorder to the UHF terminals of the TV. 3 VTR For details, refer to the instructions furnished with the recorder. pPERATION Adjusting the recorder 1 Set the rf unit channel selector to channel 3 or 4, whichever channel is not active in your area. 2 Set the recorder to the playback mode. (If you do not have a pre-recorded tape, set the TV/VTR selector to VTR and select an active channel with its channel-select button on the recorder.) The signal from the recorder will be fed to the TV. Adjusting the TV 3 Select VHF channel 3 or 4 (the operation channel of the rf unit built into the recorder) by pressing the 0 number button and 3 or 4 number button, or pressing the upper or lower CHANNEL scan button. The playback picture will then appear. Operating note If the inactive channel 3 or 4 has been erased as described before, the playback picture cannot be selected with the upper or lower CHANNEL scan button. However, the desired channel selection can again be made as usual with the number buttons.