Sony MEX BT2500 Operating Instructions - Page 12

4 Set the Bluetooth device to search for this unit. A list of detected devices appears in the display of the connecting device. This unit is displayed as "XPLOD" on the connecting device. DR-BT30Q XPLOD XXXXXXX 5 If Passcode* input is required on the display of a connecting device, input "0000." XXXX Input passcode. "0000" This unit and the Bluetooth device memorize each other's information, and when pairing is made, the unit is ready for connection to the device. About Bluetooth icons The following icons are used by this unit. lit: Bluetooth signal on flashing: Pairing standby mode off: Bluetooth signal off lit: Connection successful flashing: Connecting off: No connection lit: Connection successful flashing: Connecting off: No connection Connection If pairing has already been achieved, start operation from here. To switch the Bluetooth signal output of this unit to on To use the Bluetooth function, switch the Bluetooth signal output of this unit to on. 1 While the unit is turned off, press and hold (EQ/BLUETOOTH) until " " lights (about 3 seconds). Bluetooth signal is switched to on. " " flashes and then stays lit after pairing is complete. 6 Set the Bluetooth device to connect to this unit. " " or " " appears when the connection is made. * Passcode may be called "passkey," "PIN code," "PIN number" or "Password," etc., depending on the device. Note Pairing standby mode is not released until the connection is made. Connecting a cellular phone 1 Be sure that both this unit and a cellular phone are switched to Bluetooth signal on. 2 Connect to this unit using your cellular phone. " "appears when the connection is made. 12