Sony MEX-BT3800U Operating Instructions - Page 23
Connection, To switch the Bluetooth signal output of this unit to on, Connecting a cellular phone - specification
UPC - 027242773967
View all Sony MEX-BT3800U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Connection If pairing has already been achieved, start operation from here. To switch the Bluetooth signal output of this unit to on To use the Bluetooth function, switch the Bluetooth signal output of this unit to on. 1 Press and hold (BT) until " " lights (about 3 seconds). Bluetooth signal is switched to on. Connecting a cellular phone 1 Be sure that both this unit and the cellular phone are switched to Bluetooth signal on. 2 Connect to this unit using the cellular phone. " " appears when the connection is made. Connecting the last-connected cellular phone from this unit 1 Be sure that both this unit and the cellular phone are switched to Bluetooth signal on. 2 Press (SOURCE/OFF) repeatedly until "BT PHONE" appears. 3 Press (handsfree). " " flashes while the connection is being made. And then " " stays lit when the connection is made. Note While streaming Bluetooth audio, you cannot connect from this unit to the cellular phone. Connect from the cellular phone to this unit instead. A connecting noise may be heard over playback sound. Tip With Bluetooth signal on: when the ignition is switched to on, this unit reconnects automatically to the lastconnected cellular phone. But automatic connection also depends on the cellular phone's specification. If this unit does not reconnect automatically, connect manually. Connecting an audio device 1 Be sure that both this unit and the audio device are switched to Bluetooth signal on. 2 Connect to this unit using the audio device. " " appears when the connection is made. Connecting the last-connected audio device from this unit 1 Be sure that both this unit and the audio device are switched to Bluetooth signal on. 2 Press (SOURCE/OFF) repeatedly until "BT AUDIO" appears. 3 Press (6). " " flashes while the connection is being made. And then " " stays lit when the connection is made. Handsfree calling Check that the unit and cellular phone are connected beforehand. Receiving calls When receiving a call, a ring tone is output from your car speakers. 1 Press (handsfree) when a call is received with a ring tone. The phone call starts. To end a call Press (handsfree) again. To reject an incoming call, press and hold (handsfree) for 2 seconds. Mic Gain adjustment You can switch between two volume levels ("LOW" or "HI") to set a suitable level for the other party during a call. 1 Press (5) during a call. The item changes as follows: MIC-LOW y MIC-HI Note The microphone of this unit is located on the rear of the front panel (page 12). Do not cover the microphone with tape, etc. 23