Sony MHC-BX5 Operating Instructions - Page 36

Press ENTER., Waking up to music continued

Page 36 highlights

Waking up to music (continued) 4 Press . or > repeatedly to select "DAILY 1 (or 2)", then press ENTER. "ON" appears and the hour digits flash in the display. 1 5 Set the time to start playback. Press . or > repeatedly to set the hour, then press ENTER. The minute indication starts flashing. 1 Press . or > repeatedly on the remote to set the minute, then press ENTER. The hour indication flashes again. 6 Set the time to stop playback following the above procedure. 7 Press . or > repeatedly until the music source you want appears. The indications change as follows: t TUNER y CD PLAY T t TAPE PLAY T 8 Press ENTER. The type of timer (DAILY 1 or DAILY 2), followed by the start time, stop time and the music source, appears, then the original display appears. 9 Turn off the power. To check the setting Press CLOCK/TIMER SELECT and press . or > repeatedly to select the respective mode (DAILY 1 or DAILY 2), then press ENTER on the remote. To change the setting, start over from step 1. To cancel the timer operation Press CLOCK/TIMER SELECT and press . or > repeatedly to select "TIMER OFF", then press ENTER. Notes • You cannot activate DAILY 1 and DAILY 2 timer at the same time. • You cannot set timer if the timer on and off times are the same. • When you use the Sleep Timer, Daily Timer and Timer recording will not turn on the system until the Sleep Timer turns it off. • You cannot activate Daily Timer and Timer recording at the same time. Tip The power turns on 15 seconds before the preset time. 36

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

36
8
Press ENTER.
The type of timer (DAILY 1 or DAILY 2),
followed by the start time, stop time and
the music source, appears, then the
original display appears.
9
Turn off the power.
To check the setting
Press CLOCK/TIMER SELECT and press
.
or
>
repeatedly to select the
respective mode (DAILY 1 or DAILY 2), then
press ENTER on the remote.
To change the setting, start over from step 1.
To cancel the timer operation
Press CLOCK/TIMER SELECT and press
.
or
>
repeatedly to select “TIMER
OFF”, then press ENTER.
Notes
• You cannot activate DAILY 1 and DAILY 2 timer
at the same time.
• You cannot set timer if the timer on and off times
are the same.
• When you use the Sleep Timer, Daily Timer and
Timer recording will not turn on the system until
the Sleep Timer turns it off.
• You cannot activate Daily Timer and Timer
recording at the same time.
Tip
The power turns on 15 seconds before the preset
time.
4
Press
.
or
>
repeatedly to
select “DAILY 1 (or 2)”, then press
ENTER.
“ON” appears and the hour digits flash
in the display.
5
Set the time to start playback.
Press
.
or
>
repeatedly to set the
hour, then press ENTER.
The minute indication starts flashing.
Press
.
or
>
repeatedly on the
remote to set the minute, then press
ENTER.
The hour indication flashes again.
6
Set the time to stop playback
following the above procedure.
7
Press
.
or
>
repeatedly until
the music source you want appears.
The indications change as follows:
t
TUNER
y
CD PLAY
T
t
TAPE PLAY
T
Waking up to music (continued)
1
1