Sony MHC-V21 Operating Instructions - Page 51

DEVICE ERROR The USB device could not be recognized or an unknown device is connected. DEVICE FULL The memory of the USB device is full. ERASE ERROR Erase of audio files or folders on the USB device failed. FATAL ERROR The USB device was removed during transfer or erase operation, and may have been damaged. FOLDER FULL You cannot transfer onto the USB device because the number of folders has reached its maximum. NoDEVICE No USB device is connected or unsupported device is connected. NO DISC There is no disc in the unit. NO MUSIC No supported audio files exist in the playback source. NO SUPPORT An unsupported USB device is connected, or the USB device is connected through a USB hub. NOT USE You tried to perform a specific operation under conditions where that operation is prohibited. OVER CURRENT An over current from the (USB) port was detected. PROTECT The USB device is write-protected. PUSH STOP You tried to perform an operation that can be performed only when the playback is stopped. READING The system is reading information of the disc or USB device. Some operations are not available. REC ERROR The transfer did not start, stopped partway, or otherwise could not be performed. TRACK FULL You cannot transfer onto the USB device because the number of files has reached its maximum. Precautions When carrying the unit To avoid damaging the disc mechanism, perform the following procedure before carrying the unit. Use the buttons on the unit to perform this operation. 1 Press  to turn on the system. 2 Press FUNCTION repeatedly to select "CD". 3 Remove the disc. Press  to open and close the disc tray. Wait until "NO DISC" appears on the display. 4 Press  to turn off the system. 5 Unplug the AC power cord (mains lead). Additional Information 51US