Sony MV-900SDS Operating Instructions (primary manual) - Page 5
On heat build-up, Moisture condensation, To maintain high sound quality, Notes on cordless stereo - installing
View all Sony MV-900SDS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
On heat build-up Heat may build up in the player if it is used for an extended period of time. This, however, is not a malfunction. Moisture condensation On a rainy day or in a very damp area, moisture condensation may occur inside the lenses. Should this occur, the player will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. To maintain high sound quality Be careful not to splash juice or other soft drinks onto the player or discs. Notes on cordless stereo headphones • For your safety, do not use the headphones while driving your car. •When the headphones are not to be used for a long period of time, remove the battery to avoid damage caused by battery leakage and subsequent corrosion. •Do not leave the headphones in a location subject to direct sunlight, heat or moisture (It is recommended to use the headphones at a temperature of between 5 ˚C and 35 ˚C (41 ˚F and 95 ˚F)). • If the headphones are used while exposed to direct sunlight, sensitivity of the infrared receptor may deteriorate, and inferior quality sound may result. •Do not drop, hit or otherwise subject headphones to strong shocks of any kind. This could damage the product. •If you leave the headphones in direct sunlight, on a dash board etc., the battery may leak and burst, and cause an injury. On installation • Installing this unit requires technical expertise. This unit should be installed by a qualified technician or service personnel. • If you try to install this unit by yourself, do it properly, referring to the installation and wiring diagrams in this operating manual. Improper installation may result in fire or electric shock. • Before installation, be sure to turn the ignition switch to the OFF position or take the key out. Installing this unit with the ignition on may cause battery drain or a short circuit. • Do not damage any pipes, tubes, the fuel tank or electric wiring when installing this unit. This can cause a fire. If you drill a hole in car panels, make sure that any hidden car parts will not be damaged. • Do not use any nuts or bolts for safety devices such as steering linkage, fuel supply or braking systems. This can cause a fire or an accident. • Take care to prevent cords and wires from getting tangled or crimped in the moving portion of a seat rail. continue to next page t 5