Sony MZR500PC Operating Instructions - Page 35

Messages If the following error messages flash in the display window, check the chart below. Error message Meaning/Remedy BLANK ERROR FULL Saving • An MD with no recording on it is inserted. , Insert a recorded MD. • The disc is damaged or does not contain proper recording or editing data. , Reinsert the disc. If this fails, rerecord. • There is no more space to record on the disc (less than 12 seconds in stereo, 24 seconds in LP2 mode or monaural or 48 seconds in LP4 mode available). , Replace the disc. • The MD player is recording information (sounds) from the memory to the disk. , Wait until this process is completed. Do not expose the player to any physical shock, nor disrupt power supply. Edit • The MD player is recording information (track start and end position) from the memory to the disk. , Wait until this process is completed. Do not expose the player to physical shock, nor disrupt power supply. BUSY • You tried to operate the recorder while it was accessing the recorded data. , Wait until the message goes out (in rare cases, it may take 2-3 minutes). FULL HiDCin HOLD • You tried to enter more than 200 letters to label a single track or disc. • You tried to enter a total of more than 1,700 letters for track or disc names during playback or stop. , Enter the characters within the limit. • Voltage of the power supply is too high (The recommended AC power adaptor is not used). , Use the recommended AC power adaptor. • The recorder is locked. , Slide HOLD against the arrow to unlock the recorder (page 23). LoBATT MEMORY • Battery is weak. , Replace the dry battery (page 9). • You tried to record with the recorder placed where it receives continuous vibration. , Put the recorder on a stable place, and start recording again. 35-GB