Sony PCWA-A200 Primary User Manual - Page 20

Attaching the unit stand The unit stand allows you to place your Access Point in an upright position. When the unit stand is attached, cables are routed through the recessed groove. Before attaching the unit stand Make sure to write down the six-digit Access Point ID on the label attached on the bottom surface of the Access Point. Access Point ID Note Depending on the type of Ethernet cable used, it may be impossible to install the stand. Attach the unit stand to the Access Point as shown in the figure below. Engage Joint A with Joint B and slide the Access Point in the direction indicated by the arrow until it clicks. Joint A Joint B Groove z Tip The unit stand may be attached in either direction. To remove the unit stand Slide the Access Point and unit stand in opposite directions to detach. 20