Sony PDWF800 User Manual (PDW-700 / PDW-F800 Operation Manual for Firmware Ver - Page 90
Auto Interval Rec mode settings and, shooting, Select TAKE TOTAL TIME, and turn
View all Sony PDWF800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Chapter 4 Shooting Note Interval Rec settings cannot be made while this unit is in the following states. • The Disc Exchange Cache function is enabled. • The Clip Continuous Rec function is enabled. • During Slow & Quick Motion shooting (PDW-F800 only) • SCAN MODE on the FORMAT page of the OPERATION menu is set to "23.9P". Operation limitations during recording Item (i.LINK) Description Cannot be used. S400 connector Time code Audio signals Playback control buttons Menu operations The internal time code generator runs in R-RUN mode regardless of how the F-RUN/ SET/R-RUN switch is set. Not recorded. • Auto Interval Rec mode and the consecutive mode of Manual Interval Rec mode The EJECT, F REV, F FWD, NEXT, PREV, PLAY/PAUSE and STOP buttons are disabled. To use these buttons, stop recording by pressing the REC START button or the VTR button on the lens. • The single shot mode of Manual Interval Rec mode The F REV, F FWD, NEXT, PREV, PLAY/PAUSE, and STOP buttons are disabled. To use these buttons, exit the Interval Rec mode by pressing the EJECT button. The settings of the Interval Recrelated items on the REC FUNCTION page of the OPERATION menu cannot be changed. To change the settings, do either of the following. • Auto Interval Rec mode and the consecutive mode of Manual Interval Rec mode Stop recording by pressing the REC START button or the VTR button on the lens. • The single shot mode of Manual Interval Rec mode Exit the Interval Rec mode by pressing the EJECT button. Item Description When the • When you set the POWER camcorder power is switched off switch to OFF, the camcorder will switch off by itself after disc access has continued for a few seconds to record the picture data stored in memory. • If you remove the battery, unplug the DC cable, or cut power to the AC adaptor, picture data stored before recording stops (a maximum of ten seconds) may be lost. Take care when replacing the battery. Auto Interval Rec mode settings and shooting To make settings 1 Display the REC FUNCTION page of the OPERATION menu. For details on menu operations, see "Basic menu operations" on page 193. 2 Select CACHE/INTVAL REC, and turn the MENU knob to display "A.INT". 005 REC FUNCTION CACHE/INTVAL REC: TAKE TOTAL TIME : REC TIME : PRE-LIGHTING : DISC EXCHG CACHE: CLIP CONT REC : TOP A.INT 5MIN 5SEC OFF OFF OFF (The figure shows the PDW-700 menu.) As you turn the MENU knob, the setting changes as follows: OFF y CACHE y A.INT y M.INT. 3 Select TAKE TOTAL TIME, and turn the MENU knob to select the desired total time for shooting. As you turn the MENU knob, the setting changes as follows: 5MIN y 10MIN y 15MIN y 20MIN y 30MIN y 40MIN y 50MIN y 1H y 2H y 3H y 4H y 5H y 7H y 10H y 15H y 20H y 30H y 40H y 50H y 70H y 100H. 90 Advanced Operations for Shooting