Sony RM VL600 Operating Instructions - Page 21

If another signal has already been "learned" by that button The SET indicator flashes twice, and the Commander takes no action, returning to its state after SET was pressed and held in Step 2. Either "teach" to another free button, or clear the already "learned" function (page 22) and start over from the beginning. 3 Press and hold the button on the other remote control, until the SET indicator lights and all the Component Select buttons flash again. During data transfer, only the SET indicator stays lit, and the Component Select button turns off. If the SET indicator flashes five times It means that "learning" is incomplete. Repeat Steps 2 and 3. 4 Repeat Steps 2 and 3 to "teach" remote control signals to other buttons. 5 Press SET to finish "learning." Notes • If you do not perform Learning steps within 20 seconds at any point during the process, Learning mode ends. • If you do not perform Step 3 within 10 seconds after Step 2, the Learning procedure returns to Step 1. Repeat from Step 2 while the Component Select button is lit. To cancel "learning," press SET. Continued 21