Sony RM-VL610N Operating Instructions - Page 19

When you "teach" signals to VOL +/- or MUTING •If you used the Learning function to program the VOL +/- or MUTING buttons to send any signal to components other than the TV or AMP, that signal will be transmitted only by pressing VOL +/- or MUTING when you select that component. •If you used the Learning function to program the VOL +/- or MUTING buttons to send any signal to the TV or AMP, that signal will be transmitted only after you select TV or AMP. When you select other components, the "learned" signal will be transmitted. To "teach" the signals for an air-conditioner See "Notes on programming the signals for an air-conditioner" on page 24. For accurate Learning • Do not move the remote units during the Learning procedure. • Be sure to keep holding down the "learning" button until your Commander reacts as described. • Use fresh batteries in both remote units. • Avoid Learning in places subject to direct sunlight or a strong fluorescent light. (Noise may interfere during the Learning procedure.) • The remote control detector area may differ depending on each remote unit. If Learning does not work, try changing the positions of the two remote control units. • When you teach signals of an interactive signal exchange system remote control unit (supplied with some of Sony's amplifiers) to the Commander, the response signal of the main unit may interfere with the learning of the Commander. In such a case, move to a place where the signals will not reach the main unit (e.g. other rooms, etc.). IMPORTANT Be sure to place the Commander out of the reach of small children or pets, and lock the controls using the Hold function (page 34). Components such as air conditioners, heaters, electric appliances, and electric shutters or curtains receiving an infrared signal can be dangerous if misused. Continued 19