Sony SA-WCT100 Service Manual - Page 57
Hdmi Re Board, Ic3519, M30620fcpgp-rct01 Hdmi Controller
View all Sony SA-WCT100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
SA-WCT100/SS-MCT100 HDMI RE BOARD IC3519 M30620FCPGP-RCT01 (HDMI CONTROLLER) Pin No. Pin Name I/O Description 1 to 5 NC - Not used 6 BYTE - Not used 7 CNVSS I Processor mode switch input terminal (for test) 8, 9 NC - Not used 10 RESET I Reset signal input from the main system controller "L": reset 11 XOUT O System clock output terminal (10 MHz) 12 VSS - Ground terminal 13 XIN I System clock input terminal (10 MHz) 14 VCC_3.3V - Power supply terminal (+3.3V) 15 NMI - Not used 16 to 18 NC - Not used 19 RX_RST O Reset signal output to the HDMI receiver "L": reset 20 RX_INT I Interrupt status input from the HDMI receiver 21 RX_HPD1 O Hot plug connection detect signal output to the HDMI input selector 22 to 26 NC - Not used 27 CSCL O Serial data transfer clock signal output to the HDMI section 28 CSDA I/O Two-way data bus with the HDMI section 29 232COUT O Serial data output terminal for the RS-232C 30 232CIN I Serial data input terminal for the RS-232C 31, 32 NC - Not used 33 TX I Serial data input from the system controller 34 RX O Serial data output to the system controller 35 EEPROMSEL1 O Write enable signal output to the EEPROM 36 to 39 NC - Not used 40 VDAC_RESET - Not used 41 TX_5VPWR O Power on/off control signal output terminal "H": power on 42 TX_RST I Interrupt status input from the HDMI transceiver 43 TX_INT O Reset signal output to the HDMI transceiver "L": reset 44 to 50 NC - Not used 51 to 53 TMDS_S1 to TMDS_S3 O Source selection signal output to the HDMI input selector 54 TMDS_OEB O Output enable signal output to the HDMI input selector 55, 56 P5V_SELA, P5V_SELB O HDMI SAT IN/DVD IN/BD IN jack detection signal selection signal output terminal 57 to 59 NC - Not used 60 VCC_3.3V - Power supply terminal (+3.3V) 61 NC - Not used 62 VSS - Ground terminal 63, 64 NC - Not used 65 MUTE O Audio muting request signal output to the system controller "H": muting on 66 AD_SW - Not used 67 AD_INT - Not used 68 AD_RST - Not used 69 PROUT_RST - Not used 70 PROU_OUT_SW - Not used 71 to 90 NC - Not used 91 to 93 MODEL_SW3 to MODEL_SW1 I Model setting terminal 94 AVSS - Ground terminal 95 NC - Not used 96 VREF I Reference voltage (+3.3V) input terminal 97 AVCC - Power supply terminal (+3.3V) 98 to 100 NC - Not used 57