Sony SLV-585HF Primary User Manual - Page 13

Al e Iluipeuue3 I How to Attach the External Antenna Connector (supplied) • Loosen the screws on the antenna connector. I Fit the 300-ohm twin lead cabill on the UHF antenna under the "screws on antenna connector. : • lighten the screws again. 300-ohm twin lead cable screws How to Attach the EAC-66 UN Band Separator Mixer (not supplied) Loosen the screwson the UL. . Nrind separator/mbcer. Fit the 300-ohm twin lead cable; on the UHF antenna under the screws. 1O Connect the 75-ohm coaxial cable to the UN band • separator/mixer. • , ,41 Connect the UN band separator/mixer to the VHF/UHF IN on the • VCR. VHF/UHF IN 300-ohm twin lead cable EAC-66 75-ohm coaxial cable Setting the RF Unit • 1 RF UNIT IR3 CH 4 CH 2 3 • O 0 =I=1 0 0 10I 0 kw) ."" .201.00 , Why this setting is necessary Your TV receiver must be set to receive the signal from your VCR. To get the proper RF signal, set the RF UNIT selector switch on the rear panel of the VCR. If channel 4 is active in your area, set the switch to 3 CH, and vice-versa. If you connect a color monitor or a TV equipped with video/audio input jacks, you do not need to make this setting. 1 Set the RF UNIT at the rear of the VCR to 3 CH or 4 CH, whichever is not active in your area. 2 Press POWER. The indicator will light. 3 Press ANT TVNTR so that the VTR indicator lights. 4 Check that the TUNER Indicator appears in the display window, then select an active channel in your area by pressing CHANNEL +/-. 5 Turn on the TV and set the TV to the channel selected in step 1. The TV program selectd on the VCR will appear on the screen. Your TV is now tuned to the VCR. Whenever you use the VCR, set the TV to the channel selected above. Note For details about TV channel adjustment, see the instruction manual of the TV. 1 13 Getting Started