Sony STR-DA3200ES Operating Instructions (Large File - 16.41 MB) - Page 46

Confirming/saving the measurement results 1 Confirm the measurement result. When the measurement ends, a beep sounds and the measurement result appears on the display. Measurement Display Explanation result When the measurement process completes properly COMPLETE Proceed to step 2. When the measurement process fails ERROR CODE XX See "When error codes appear" (page 46). 2 Press V/v repeatedly to select the item, then press . Item Explanation RETRY Re-performs the auto calibration. SAVE EXIT Saves the measurement results and exits the setting process. WRN CHECK Displays a warning concerning the measurement results. See "When you select "WRN CHECK"" (page 47). PHASE INFO Displays the phase of each speaker (in phase/out of phase). See "When you select "PHASE INFO"" (page 47). 46GB Item Explanation DIST.INFO Displays the measurement result for speaker distance. LEVEL INFO Displays the measurement result for speaker level. EXIT Exits the setting process without saving the measurement results. 3 Press V/v repeatedly to select a preset number to be used, then press . 4 Press . The measurement results are saved. Tip The size of a speaker (LARGE/SMALL) is determined by the low characteristics. The measurement results may vary, depending on the position of the optimizer microphone and speakers, and the shape of the room. It is recommended that you follow the measurement results. However, you can change those settings in the Speaker Settings menu (page 68). Save the measurement results first, then try to change the settings if you want. When error codes appear Try the remedies and re-perform the auto calibration. Error code Cause and remedies CODE 31 CODE 32 CODE 33 (F) SPEAKERS (OFF/A/B/A+B) is set to OFF. Set it to others and reperform the auto calibration. None of the speakers were detected. Make sure that the optimizer microphone is connected properly and reperform the auto calibration. If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected. None of the front speakers are connected or only one front speaker is connected. The optimizer microphone is not connected.