Sony STR-DA3200ES Operating Instructions (Large File - 16.41 MB) - Page 47

Getting Started Error code Cause and remedies CODE 33 (SR) • Either the left or right surround speakers is not connected. • Surround back speakers are connected even though surround speakers are not connected. Connect the surround speaker to the SURROUND terminal. CODE 33 (SB) The surround back speaker is connected only to the SURROUND BACK SPEAKERS R terminal. When you connect only one surround back speaker, connect it to the SURROUND BACK SPEAKERS L terminal. •CODE 31 1 Press , then follow the instructions from step 1 of "Performing the auto calibration." •CODE 32, 33 1 When you press , "RETRY?" appears. 2 Press V/v to select "YES," then press . 3 Follow the instructions from step 2 of "Performing the auto calibration." 4 Press V/v repeatedly to select preset number to store preset settings then press . When you select "WRN CHECK" If a warning on the measurement result is present, detailed information is displayed. Press to return to step 1 of "Confirming/saving the measurement results." Warning code Explanation WARNING 40 The auto calibration has completed. However, the noise level is high. You may be able to perform the auto calibration properly if you try it again, even though the measurement cannot be performed in all environments. Try to perform the auto calibration in a quiet environment. Warning code Explanation WARNING 41 The sound input from the optimizer microphone is outside the acceptable range. It is louder than the loudest sound that can be measured. Try to perform the auto calibration when the environment is quiet enough to allow proper measurement. WARNING 42 The volume of the receiver is out of the acceptable range. Try to perform the auto calibration when the environment is quiet enough to allow proper measurement. WARNING 43 The distance and position of a sub woofer cannot be detected. Or the angle of the speaker position cannot be detected. This may be caused by noise. Try to perform the auto calibration in a quiet environment. NO WARNING There is no warning information. When you select "PHASE INFO" You can check the phase of each speaker (in phase/out of phase). Press V/v repeatedly to select a speaker, then press to return to step 1 in "Confirming/saving the measurement results." continued 47GB