Sony STR-DB1070 Operating Instructions (primary manual) - Page 40

Preset tuning (continued) Presetting radio stations 1 Rotate FUNCTION to select TUNER. The last received station is tuned in. 2 Tune in the station that you want to preset using Direct Tuning (page 38) or Automatic Tuning (page 39). 3 Press MEMORY. "MEMORY" appears in the display for a few seconds. Do steps 4 to 6 before "MEMORY" goes out. 4 Press SHIFT to select a memory page (A, B or C). Each time you press SHIFT, the letter "A", "B", or "C" appears in the display. 5 Press PRESET TUNING + or PRESET TUNING - to select a preset number. If "MEMORY" goes out before you press the preset number, start again from step 3. 6 Press MEMORY again to store the station. If "MEMORY" goes out before you press the preset number, start again from step 3. 7 Repeat steps 2 to 6 to preset another station. To change a preset number to another station Do steps 1 to 6 to preset a new station to the number. Tuning to preset stations You can tune the preset stations by either of the following two ways. Scanning the preset stations 1 Rotate FUNCTION to select TUNER. The last received station is tuned in. 2 Press PRESET TUNING + or PRESET TUNING - repeatedly to select the preset station you want. Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows: nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N nC0˜...C2˜C1N Using the preset codes Use the supplied remote to perform the following operations. For details on the buttons used in this section, see the operating instructions for the supplied remote. 1 Rotate FUNCTION to select TUNER. The last received station is tuned in. 2 For remotes without a display: Press SHIFT to select a memory page (A, B, or C), then press the preset number of the station you want using the numeric buttons. For remotes with a display: Select the preset station you want from the list displayed on the supplied remote. 40