Sony STR-DE898 Operating Instructions - Page 13

Getting Started L Hooking up video components If you connect your TV to the MONITOR jacks, you can watch the video from the selected input (page 23). For details on the required cords (A-H), see page 6. VCR INPUT OUTPUT VIDEO VIDEO IN OUT AUDIO AUDIO IN OUT L R B B OUT IN TV monitor INPUT VIDEO INPUT S VIDEO CD L To the VIDEO 3 IN/PORTABLE AV IN jacks (Front panel) DIGITAL ANTENNA Y OPTICAL TV/SAT IN MD/ TAPE IN MD/ TAPE OUT SA-CD/ CD IN S-VIDEO S-VIDEO IN IN S-VIDEO S-VIDEO S-VIDEO PB/CB OUT IN OUT /B-Y AM PR/CR /R-Y VIDEO IN VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT L L L MONITOR TV/SAT DVD IN IN ASSIGNABLE MONITOR OUT COMPONENT VIDEO DVD IN SA-CD/ CD IN COAXIAL ASSIGNABLE (INPUT ONLY) SIGNAL GND L R IN IN PHONO SA-CD/CD R R R AUDIO IN AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT AUDIO IN TV/SAT DVD VIDEO 2 VIDEO 1 L L L CENTER L R OUT IN MD/TAPE R R SURR SUB R SUB FRONT SURROUND BACK WOOFER OUT WOOFER MULTI CH IN 2ND ZONE PRE OUT + - CENTER SPE L L L L B Camcorder or video game OUT B OUT IN B D IN D INPUT OUTPUT VIDEO VIDEO IN OUT AUDIO AUDIO IN OUT L R INPUT S VIDEO VCR OUTPUT S VIDEO Tips • When using the S-video jacks instead of the video jacks, your monitor must also be connected via an S-video jack. S-video signals are on a separate bus from the video signals and will not be output through the video jacks. • On this receiver, standard video signals can be converted to component video or S-video signals and S-video signals can be converted to component video signals. These upconverted video signals can only be output from the MONITOR VIDEO OUT jack. However, you cannot convert the component video signals to standard video or S-video signals. • When standard video signals (composite video signals) or S-video signals from a VCR etc. are converted upward on this receiver and then output to your TV, depending on the status of the video signal output, the image on the TV screen may appear distorted horizontally or no image may be output. 13GB