Sony STR-DG500 Service Manual - Page 2

STR-DG500/DG600 Ver. 1.1 1) Measured under the following conditions: Area code US, CND AEP, UK, KR, MY, SP, TH E2, AUS TW Power requirements 120 V AC, 60 Hz 230 V AC, 50 Hz 240 V AC, 50 Hz 110 V AC, 60 Hz 2) Reference power output for front, center, surround and surround back. Depending on the sound field settings and the source, there may be no sound output. 3) Measured under the following conditions: Area code KR, TH Power requirements 220 V AC, 50 Hz Frequency response Analog 10 Hz - 70 kHz +0.5/-2 dB (with sound field and tone (DG500) or equalizer (DG600) bypassed) Inputs Analog Sensitivity: 500 mV/ 50 kohms S/N 4) : 96 dB (A, 500 mV 5) ) Digital (Coaxial) Impedance: 75 ohms S/N: 100 dB (A, 20 kHz LPF) Digital (Optical) S/N: 100 dB (A, 20 kHz LPF) Output (Analog) AUDIO OUT Voltage: 500 mV/10 kohms SUB WOOFER, SURROUND (DG600) Voltage: 2 V/1 kohm Tone (DG500), EQUALIZER (DG600) Gain levels ±6 dB, 1 dB step 4) INPUT SHORT (with sound field and tone (DG500) or equalizer (DG600) bypassed). 5) Weighted network, input level. FM tuner section Tuning range 87.5 - 108.0 MHz Intermediate frequency 10.7 MHz Useable sensitivity 11.2 dBf, 1 µV/75 ohms S/N Mono/Stereo 76 dB/70 dB Harmonic distortion at 1 kHz Mono/Stereo 0.3%/0.5% Separation 45 dB at 1 kHz Frequency response 30 Hz - 15 kHz, +0.5/-2 dB AM tuner section Tuning range Models of area code US, CND With 10-kHz tuning scale: 530 - 1,710 kHz 6) With 9-kHz tuning scale: 531 - 1,710 kHz 6) Models of area code E2 With 10-kHz tuning scale: 530 - 1,610 kHz 6) With 9-kHz tuning scale: 531 - 1,602 kHz 6) Models of area code AEP, UK, AUS, TW, KR, SP, MY, TH With 9-kHz tuning scale: 531 - 1,602 kHz Intermediate frequency 450 kHz Usable sensitivity 50 dB/m (at 1,000 kHz or 999 kHz) 6) You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. While holding down TUNING MODE, press ?/1. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure. Video section Inputs/Outputs Video: S-video (DG600): COMPONENT VIDEO: 1 Vp-p, 75 ohms Y: 1 Vp-p, 75 ohms C: 0.286 Vp-p, 75 ohms Y: 1 Vp-p, 75 ohms PB/CB/B-Y: 0.7 Vp-p/ 75 ohms PR/CR/R-Y: 0.7 Vp-p/ 75 ohms 80 MHz HD Pass Through General Power requirements Area code US, CND AEP, UK AUS KR, TH E2 TW SP, MY Power requirements 120 V AC, 60 Hz 230 V AC, 50/60 Hz 240 V AC, 50 Hz 220 - 230 V AC, 50/60 Hz 120/220/240 V AC, 50/60 Hz 110 V AC, 50/60 Hz 230 - 240 V AC, 50/60 Hz Power consumption Area code DG500: US, AEP, UK, AUS, KR, E2 DG500: SP, MY, TH DG500: CND DG500: TW DG600: US DG600: CND DG600: E2 DG600: SP, MY, TH Power consumption 220 W 200 W 300 VA 500 W 230 W 310 VA 230 W 210 W Power consumption (during standby mode) 0.2 W AC outlets (DG600) Area code US, CND E2, SP, MY, TH AC outlets 1 switched, 120 W/1A MAX 1 switched, 100 W/0.4A MAX Dimensions (w/h/d) (Approx.) 430 × 157.5 × 316 mm (16 7/8 × 6 2/8 × 12 4/8 inches) including projecting parts and controls Mass (Approx.) 8.0 kg (17 lb 11 oz) Supplied accessories FM wire antenna (1) AM loop antenna (1) Remote commander RM-AAU005 (1) (DG500) Remote commander RM-AAP012 (1) (DG600: US, CND) Remote commander RM-AAP013 (1) (DG600: E2, MY, SP, TH) R6 (size-AA) batteries (2) Optimizer microphone ECM-AC2 (1) Design and specifications are subject to change without notice. • Abbreviation CND : Canadian model E2 : 120 V AC area in E model TW : Taiwan model AUS : Australian model KR : Korea model MY : Malaysia model SP : Singapore model TH : Thai model 2