Sony STR-K900 Service Manual - Page 13
Vacs Control, Swap All Mode, Dcac Factory Test Mode - 5 1 receiver
View all Sony STR-K900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
VACS CONTROL Procedure: 1. While depressing the TUNING MODE and the MUSIC buttons simultaneously, press the power ?/1 button to turn on the main power. 2. "VACS OFF" appears. (10 second) SWAP ALL MODE Procedure: 1. While depressing the SPEAKERS (OFF/A/B/A+B) and the A.F.D. buttons simultaneously, press the power ?/1 button to turn on the main power. 2. "SWP.ALL" appears. (No change while displayed.) DCAC FACTORY TEST MODE DCAC Factory Test mode have two stages: 1. DCAC DSP Data Line Checking 2. DCAC AUTO CAL MIC board Checking Start DSP Data Line Pass Check Auto Cal Mic Check Pass END Factory Test System Setup Receiver DCAC MIC SPK Front Left 1. When power off : Press the three buttons TUNING + + MOVIE + ?/1 . "DCAC[]FTM" appears. Afterward, press the TUNING MODE to start DCAC factory test mode. 1. DCAC DSP Data Line Checking After press the TUNING MODE , DCAC Factory test mode will start, below display will show: "DCAC[][][]x" x = 1, 2, 3, 4 If there is error happen, below display will show: "ERR[]SD0x" x = 1 → D1501 or R1530 or C1512 problem x = 2 → D1502 problem x = 3 → D1503 problem x = 4 → D1504 problem 2. DCAC AUTO CAL MIC board Checking Connect front left speaker of the receiver and AUTO CAL microphone. Turn MASTER VOLUME jog, there will be test tone sound output from front left speaker, and the display will change accordingly. "AD[]-[]xxx" xxx = 0 to 255 (depends on loudness of test tone) STR-K880/K900 13