Sony STRDA3500ES Operating Instructions - Page 130
Setting remote control codes that are not stored in the remote, While holding down RM SET
UPC - 027242754355
View all Sony STRDA3500ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Setting remote control codes that are not stored in the remote Even if a remote control code is not one of the presets stored in the remote, it is possible for the remote to learn the code using the learning function. Note When setting up the receiver to learn the remote command modes, replace the batteries with new ones. RM SET UP THEATER ?/1 SHIFT TV Input buttons Buttons used to learn code* 1 While holding down RM SET UP, press THEATER. The RM SET UP button lights up. 2 Press the input button (including the TV button) for the component you want to operate with the new command. The input button flashes. (The RM SET UP button remains lit.) 3 Press the button on which you want to store the new command. For the buttons with an asterisk in the illustration above, press SHIFT, then press the button. The input button you selected in step 2 lights up. (The RM SET UP button remains lit.) 4 Point the remote code receiver section of the remote towards the receiver/transmitter on the remote control to be learned from. About 5 cm - 10 cm (2" - 4") Buttons used to learn code * To store a new command on one of those buttons, press SHIFT beforehand. 5 Press the button on the remote commander to be learned from to transmit the remote code. While the remote of the receiver is receiving the signal, the input button selected in step 2 turns off. The RM SET UP button flashes twice, then the learning process is completed. When the learning process fails, the RM SET UP button flashes five times. Try to perform the process again from step 2. 130US