Sony UHP-H1 Operating Instructions - Page 39

Bluetooth connection Bluetooth connection cannot be done/ completed. , Set [Bluetooth Mode] to [On] (page 30). , Make sure the Bluetooth device to be connected is turned on and the Bluetooth function is enabled. , Move the Bluetooth device closer to the player. , Connect this player and the Bluetooth device again. You may need to cancel the connection with this player using your Bluetooth device first. , Delete pairing information once from the device list and connected device, before retrying connection. , Connection may not be possible if other Bluetooth devices are present around the player. In this case, turn off the other Bluetooth devices. , The connection registration information has been erased. Perform the connection operation again. There is no sound, the sound skips or fluctuates, or the connection is lost. , DVD AUDIO cannot be played via Bluetooth device due to DRM. , Move the Bluetooth device closer to the player. , Make sure the player is not receiving any interference from a Wi-Fi network, other Bluetooth device, other 2.4 GHz wireless device, or microwave oven. , Check that the Bluetooth connection is properly made between this player and the Bluetooth device. , Connect this player and the Bluetooth device again. , Keep the player away from metal objects or surfaces. Control for HDMI (BRAVIA Sync) The [Control for HDMI] function does not work (BRAVIA Sync). , Check that your TV is connected via the HDMI OUT 1 jack. If your TV is connected via the HDMI OUT 2 jack, BRAVIA Sync is disabled. , Check that [Control for HDMI] in [HDMI Settings] is set to [On] (page 33). , If you change the HDMI connection, turn the player off and on again. , If power failure occurs, set [Control for HDMI] in [HDMI Settings] to [Off], then set [Control for HDMI] in [HDMI Settings] to [On] (page 33). , Check the following and refer to the instruction manual supplied with the component. - the connected component is compatible with the [Control for HDMI] function. - the connected component's setting for the [Control for HDMI] function is correct. , When you connect the player to a TV through an AV amplifier (receiver), - if the AV amplifier (receiver) is not compatible with the [Control for HDMI] function, you may be unable to control the TV from the player. - if you change the HDMI connection, disconnect and reconnect the AC power cord, or a power failure occurs, try the following: 1Switch the input selector of the AV amplifier (receiver) so that the picture from the player appears on the TV screen. 2Set [Control for HDMI] in [HDMI Settings] to [Off], then set [Control for HDMI] in [HDMI 39 Additional Information