Sony VPL-CS2 Operating Instructions - Page 16
Connecting the Projector, Connecting with a Computer
View all Sony VPL-CS2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Connecting the Projector When making connections, be sure to do the following: • Turn off all equipment before making any connections. • Use the proper cables for each connection. • Insert the cable plugs properly; plugs that are not fully inserted often generate noise. When pulling out a cable, be sure to pull it out from the plug, not the cable itself. Connecting with a Computer This section describes how to connect the projector to a computer. For more information, refer to the computer's instruction manual. Notes • The projector accepts VGA, SVGA, XGA, and SXGA signals. However, we recommend that you set the output mode of your computer to SVGA (VPL-CS2) or XGA (VPL-CX1) mode for the external monitor. • If you set your computer, such as a notebook type, to output the signal to both your computer's display and the external monitor, the picture of the external monitor may not appear properly. Set your computer to output the signal to only the external monitor. For details, refer to the computer's operating instructions supplied with your computer. • Supplied mouse cable may not work properly according to your computer. • This projector is compatible with a DDC2B (Digital Data Channel 2B). If your computer is compatible with a DDC, turn the projector on according to the following procedures. 1 Connect the projector to the computer by using the supplied HD D-sub 15 pin cable. 2 Turn the projector on. 3 Start the computer. GB 16 Connecting the Projector