Sony VPL-EW130 Operating Instructions - Page 19

Adjustments and Settings Using a Menu The SET SETTING Menu The SET SETTING menu is used for setting various functions of the projector. Items Item descriptions Smart APA On/Off: When set to "On," executes APA automatically when a signal is input.*1 *2 Auto Input Search On/Off: When set to "On," the projector detects input signals in the following order: Input-A/Input-B/Video. It indicates the input channel when the power is turned on or the INPUT key is pressed. Input-A Signal Sel. Auto/Computer/Component/Video GBR: When set to "Auto," selects the type of video signal input automatically when "Input-A" is selected with the INPUT key.*3 Color System Auto/NTSC3.58/PAL/PAL-60/SECAM/NTSC4.43/PAL-M/PAL-N: When set to "Auto," selects the color system automatically when "Video" is selected with the INPUT key.*3 Power Saving Mode Off: The Power Saving Mode is canceled. Lamp Cutoff: The lamp turns off automatically and power consumption is reduced if no signal is input for 10 minutes. The lamp lights again when a signal is input or any key is pressed. In Lamp Cutoff, the ?/1 key lights in orange (page 23). Standby: The power will be turned off automatically and the projector goes to Standby mode if no signal is input for 10 minutes. Panel Key Lock On/Off: When set to "On," locks all the control panel keys of the projector. However, you can operate the following when set to "On": • Press and hold the ?/1 key for approximately 10 seconds during Standby mode. c The projector turns on. • Press and hold the ?/1 key for approximately 10 seconds during power on. c The projector goes to Standby mode. • Press and hold the MENU key for approximately 10 seconds during power on. c "Panel Key Lock" is set to "Off" and enables operation of all keys on the projector. CC Display CC1/CC2/CC3/CC4/Text1/Text2/Text3/Text4: Select the closed caption service (Captions or Text). Off: Closed caption does not appear. Lamp Timer Reset When replacing the lamp, resets the lamp timer (page 27). Note *1: Executes APA when a computer signal is input via the RGB input connector (INPUT A). *2: If the projected image includes large amount of black portion around it, the APA function will not work properly and a part of the image may not be displayed on the screen and also optimum image cannot be obtained, depending on the type of input signal. In this case, adjust the "Dot Phase," "H size," and "Shift" items manually. *3: The image may not be adjusted properly depending on the type of input signal. In such a case, adjust it manually to suit to the connected equipment. The SET SETTING Menu 19