Sony VPL-EX120 Operating Instructions - Page 27
Messages List
View all Sony VPL-EX120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Messages List When any of the messages listed below appears on the projected image, address the problem in accordance with the table below. Message Meaning/Remedy Page High temp.! Lamp off in 1 min. Check the items below. • Check to see if nothing is blocking the ventilation holes. • Check to see if the air filter is not clogged. • Check if "Installation Attitude" on the Installation menu is correctly selected. 3, 21, 32 Frequency is out of range! Change the output setting of the connected equipment to one 37 for signals supported by the projector. Please check Input-A Set "Input-A Signal Sel." to "Auto" or select the input signal 20 Signal Sel. type to suit to the input signal. Please replace the Lamp and clean the Filter. Replace the lamp with a new one and clean the air filter. To cancel the message, press any key on the Remote Commander or the control panel of the projector. The message appears whenever you turn on the power until you replace the lamp and reset the lamp timer. 30, 32 Projector temperature is high. High Altitude Mode should be "On" if the projector is being used at high altitude. At an altitude of 1,500 m or higher, if you are not using the projector, check the items below. • Check that nothing is blocking the ventilation holes. • Check that the air filter is not clogged. • Check if "Installation Attitude" on the Installation menu is correctly selected. 3, 21, 32 Not applicable! Invalid key pressed. - The panel keys are "Panel Key Lock" is set to "On." 19 locked! Others Messages List 27