Sony XAV-AX200 Operating Instructions - Page 33
Installation, Mounting the unit in a Japanese car, Using the wired remote control
![]() |
View all Sony XAV-AX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Cautions • It is extremely dangerous if the cord becomes wound around the steering column or gearstick. Be sure to keep it and other parts from interfering with your driving operations. • If airbags or any other shock-absorbing equipment are in your car, contact the store where you purchased this unit or the car dealer before installation. Note Before attaching the double-sided tape , clean the surface of the dashboard with a dry cloth. Using the wired remote control When using the steering wheel remote control Installation of the connection cable RC-SR1 (not supplied) is required before use. 1 To enable the steering wheel remote control, select [General Settings] [Steering Control Custom] to make the registration (page 16). When the registration is complete, the steering wheel remote control becomes available. Notes on installing the connection cable RC-SR1 (not supplied) • Refer to the support site on the back cover for details then connect each lead properly to the appropriate leads. Making an improper connection may damage the unit. • Consulting the dealer or an experienced technician for help is recommended. When using the wired remote control 1 To enable the wired remote control, set [Steering Control] in [General Settings] to [Preset] (page 16). Using the rear view camera Installation of the rear view camera (not supplied) is required before use. The picture from a rear view camera connected to the CAMERA IN (REAR) terminal is displayed when: the back lamp of your car lights up (or the shift lever is set to the R (reverse) position). you press HOME, touch [Camera], then touch [Rear]. Installation Mounting the unit in a Japanese car You may not be able to install this unit in some Japanese cars. In such a case, consult your Sony dealer. To the dashboard/center console Bracket Bracket Parts supplied with your car When mounting this unit to the preinstalled brackets of your car, use the supplied screws in the appropriate screw holes based on your car: T for TOYOTA and N for NISSAN. Note To prevent a malfunction, install only with the supplied screws . Fuse replacement When replacing the fuse, be sure to Fuse (10 A) use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. 33GB
![](/manual_guide/products/sony-xavax200-operating-instructions-f84c46a/33.png)