Sony XBR-52LX900 Setup Guide (Operating Instructions) - Page 6
Setting up your TV, Attaching the Table-Top Stand (except XBR-60LX900 - 3d tv
View all Sony XBR-52LX900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Setting up your TV Some TV models are packaged with a detached Table-Top Stand so you can mount your TV to a wall right away. If you are not mounting the TV to a wall, you will need to attach the TableTop Stand. You will need a Phillips screwdriver and the supplied screws to complete the task. Look for the supplied TableTop Stand instruction leaflet. Be sure to consider the following while setting up your TV: • Disconnect all cables when carrying the TV. • Carry the TV with the adequate number of people; larger size TVs require two or more people. • Correct hand placement while carrying the TV is very important for safety and to avoid damage. • Do not expose the Intelligent Presence Sensor to direct sunlight or other strong light, as malfunction may occur. Attaching the Table-Top Stand (except XBR-60LX900) Refer to the supplied Table-Top Stand instruction leaflet for proper attachment for some TV models. 1 Gently slide the TV unit onto the Table-Top Stand and align the screw holes. ~ • Do not put stress on the LCD panel or the frame around the screen. • Be careful to not pinch your hands or the AC power cord when you install the TV unit to the Table-Top Stand. • Ensure your TV has adequate ventilation, see page 15. • For best picture quality, do not expose the screen to direct illumination or sunlight. • Avoid installing the TV in a room with reflective wall and floor materials. • Avoid moving the TV from a cold area to a warm area. Sudden room temperature changes may cause moisture condensation. This may cause the TV to show poor picture and/or poor color. Should this occur, allow moisture to evaporate completely before powering the TV on. • Ensure that there are no objects in front of the TV. IR Sensor 2 Use the supplied screws to attach the TV unit to the Table-Top Stand. 3D Sync Transmitter Intelligent Presence Sensor ~ • If you use an electric screwdriver, set the tightening torque at approximately 1.5 N·m {15 kgf·cm}. 6