Sony XBR-65X800G Reference Guide - Page 4
Securing the TV, Preventing the TV from Toppling, Recommended Measures to Secure the, hardware - a tv
View all Sony XBR-65X800G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
• Correct hand placement while carrying the TV is very important for safety and to avoid damage. • Ensure your TV has adequate ventilation, see page 17. • For best picture quality, do not expose the screen to direct illumination or sunlight. • Avoid installing the TV in a room with reflective wall and floor materials. • Avoid moving the TV from a cold area to a warm area. Sudden room temperature changes may cause moisture condensation. This may cause the TV to show poor picture and/or poor color. Should this occur, allow moisture to evaporate completely before powering the TV on. Securing the TV Sony strongly recommends taking measures to prevent the TV from toppling over. Unsecured TVs may topple and result in property damage, serious bodily injury or even death. Preventing the TV from Toppling • Secure the TV to a wall and/or Stand. • Do not allow children to play or climb on furniture and TV sets. • Avoid placing or hanging items on the TV. • Never install the TV on: slippery, unstable and/or uneven surfaces. furniture that can easily be used as steps, such as a chest of drawers. • Install the TV where it cannot be pulled, pushed, or knocked over. • Install the TV so that the TV's Table-Top Stand does not protrude out from the Stand (not supplied). If the TableTop Stand protrudes out from the Stand, it may cause TV set to topple over, fall down, and cause personal injury or damage to the TV. Recommended Measures to Secure the TV Consider the following measures when securing your TV to a Stand (not supplied). 1 Secure the Stand for the TV. Make sure the Stand can adequately support the weight of the TV. Use two angle braces (not supplied) to secure the Stand. For each angle brace use the appropriate hardware to: • Attach one side of the angle brace to the wall stud. • Attach the other side to the Stand. Angle brace (not supplied) Stand 2 Secure the TV to the Stand. Use the optional hardware listed as follows (not supplied): • M6 machine screws (screwed into the TV's rear cover). • A screw or similar (attach it to the Stand). • Rope or chain (strong enough to support the weight of the TV). Make sure that there is no excess slack in the rope or chain. Screw hole on the rear cover M6 machine screw (not supplied) Rope or chain (not supplied) 22 1.5 N·m {15 kgf·cm} • Route all AC power cords and connecting cables so that they are not accessible to curious children. Screw (not supplied) The length of the M6 machine screw differs depending on the rope or chain diameter. Please refer to below illustration. 8 mm - 12 mm Screw M6 Rope or chain TV's rear cover 4US