Stihl 046 Instruction Manual - Page 15
of ANSI standard B 175.1
View all Stihl 046 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
It may also occur during limbing. The greater the force of the kickback reaction, the more difficult it becomes for the operator to control the saw. Many factors influence the occurrence and force of the kickback reaction. These include chain speed, the speed at which the bar and chain contact the object, the angle of contact, the condition of the chain and other factors. The type of bar and saw chain you use is an important factor in the occurrence and force of the kickback reaction. Some STIHL bar and chain types are designed to reduce kickback forces. STIHL recommends the use of reduced kickback bars and low kickback chains. ANSI B 175.1-1991 chainsaw kickback standard Section 5.12 of ANSI standard B 175.1- 1991, sets certain performance and design criteria related to chainsaw kickback. To comply with section 5.12 of ANSI B 175.1-1991: a) saws with a displacement of less than 3.8 cubic inches - must, in their original condition, meet a 45° computer derived kickback angle when equipped with certain cutting attachments. - and must be equipped with at least two devices to reduce the risk of kickback injury, such as a chain brake, low kickback chain, reduced kickback bar, etc. b) saws with a displacement of 3.8 cubic inches and above - must be equipped with at least one device designed to reduce the risk of kickback injury such as a chain brake, low kickback chain, reduced kickback bar, etc. The computer derived angles for saws below 3.8 cubic inch displacement are measured by applying a computer program to test results from a kickback test machine. angles that may occur in real life cutting situations. Compliance with § 5.12 of ANSI B 175.1-1991 does not automatically mean that in a real life kickback the bar and chain will rotate at most 45°. !Warning! In order for powerheads below 3.8 cubic inch displacement to comply with the computed kickback angle requirements of § 5.12 of ANSI B 175.1-1991 use only the following cutting attachments: - bar and chain combinations listed as complying in the "Specifications" section of the Owner's Manual or - other replacement bar and chain combinations marked in accordance with the standard for use on the powerhead or - replacement chain designated "low kickback saw chain''. See the section on "Low kickback saw chain and reduced kickback bars" !Warning! The computer derived angles of § 5.12 of ANSI B 175.1-1991 may bear no relationship to actual kickback bar rotation 13