Stihl HS 82 R Product Instruction Manual - Page 11

WARNING The cutter blades continue to move for a short period after the throttle trigger is released (flywheel effect.) Accelerating the engine while the blades are blocked increases the load and will cause the clutch to slip continuously. This may result in overheating and damage to important components (e.g. clutch, polymer housing components) - which can then increase the risk of injury from the blades moving while the engine is idling. WARNING Before you start work, examine the hedge area for stones, fence wire, metal or other solid objects which could damage the cutter blades. Take particular care when cutting hedges next to or against wire fences. Do not touch the wire with the cutting blades. When working close to the ground, make sure that no sand, grit or stones get between the cutter blades. Striking solid foreign objects such as stones, fence wire or metal could damage the cutting attachment and may cause blades to crack, chip or break. STIHL does not recommend the use of your power tool when cutting in areas where the blades could contact such objects. WARNING Observe the cutting blades at all times - do not cut any areas of the hedge that you cannot see. When cutting the top of a taller hedge, check the other side of the hedge frequently for bystanders, animals and obstructions. DANGER Your power tool is not insulated against electric shock. To reduce the risk of electrocution, never operate this power tool in the vicinity of any wires or cables (power, etc.) which may be carrying electric current. WARNING If the cutting tool becomes clogged or stuck, always turn off the engine and make sure the cutting tool has stopped before cleaning. Grass, weeds, etc. should be cleaned off the cutting tool at regular intervals. Check the cutting blades at regular short intervals during operation, or immediately if there is a noticeable change in cutting behavior: - Shut off the engine. - Wait until the cutting blades have come to a complete standstill. - Check condition and tightness, look for cracks. - Check sharpness. - Replace damaged or dull cutting tools immediately, even if they have only superficial cracks. English WARNING The gearbox becomes hot during operation. To reduce the risk of burn injury, do not touch the gear housing when it is hot. WARNING Never modify your muffler. Any modification could cause an increase in heat radiation, sparks or sound level, thereby increasing the risk of fire, burn injury or hearing loss. You may also permanently damage the engine. Have your muffler serviced and repaired by your STIHL servicing dealer only. WARNING The muffler and other parts of the engine (e.g. fins of the cylinder, spark plug) become hot during operation and remain hot for a while after stopping the engine. To reduce risk of burns, do not touch the muffler and other parts while they are hot. Keep the area around the muffler clean. Remove excess lubricant and all debris such as pine needles, branches or leaves. Let the engine cool down sitting on concrete, metal, bare ground or solid wood (e.g. the trunk of a felled tree) away from any combustible substances. WARNING An improperly mounted or damaged cylinder housing or a damaged/deformed muffler shell may interfere with the cooling process of the muffler. To reduce the risk of fire or burn injury, do not continue work with a HS 82 R, HS 82 T 9