Stihl HSE 52 Product Instruction Manual - Page 7

It may be carried only in the horizontal position. Grip the front handle and keep the cutter blades behind you. WARNING Always release the trigger switch and front handle switch lever, disconnect the unit from the power supply and fit the scabbard over the cutter blades before transporting the power tool over long distances. When transporting it in a vehicle, properly secure it to prevent turnover and damage to the unit. Preparation for Use WARNING Never use a power tool that is damaged or not properly maintained. WARNING Before connecting the hedge trimmer to the power supply, always check it for proper condition and operation, including the trigger switch, front handle switch lever, cutting blades with integral blade guard and hand guard. The trigger switch and front handle switch must both move freely and always spring back to the off position. Never attempt to tamper with the switches or to modify the other controls or safety devices. 9930BA015 KN WARNING Inspect the power supply cord, plug and extension cord before and after each use for signs of damage or aging. WARNING Disconnect plug from the power supply immediately if the cord is damaged or cut. Inspect the power supply cord, plug, extension cord and housing before use and periodically during use. In order to reduce the risk of serious injury from electrocution, never use your hedge trimmer if the power supply cord, extension cord or plugs are cut, cracked, worn or damaged or if the housing is broken or cracked. Disconnect the plug from the power supply and have a dealer replace a damaged power supply cord and/or repair a broken or cracked housing. Immediately replace any damaged extension cords. WARNING Your hedge trimmer is equipped with a mechanical sprocket brake designed to bring the cutting blades immediately to a stop when one or both switches are released. To reduce the risk of cut injuries, do not operate your hedge English trimmer if the cutting blades do not stop immediately. Have your unit repaired by a servicing STIHL dealer. WARNING Keep the handles clean and dry at all times; it is particularly important to keep them free of moisture, pitch, oil, grease or resin in order for you to maintain a firm grip and properly control your power tool. WARNING The cutting tool must be properly tightened and in safe operating condition. Inspect for loose parts (nuts, screws, etc.) and for cracked, bent, warped or damaged blades. Regularly check the condition and tightness of the cutting blades - with the hedge trimmer disconnected from the power supply! Replace damaged cutting blades before using the power tool again. Always keep blades sharp. STIHL recommends that you always spray the cutting blades with STIHL resin solvent before connecting the hedge trimmer to the power supply! You can obtain this protective spray from your dealer. Apply generously. During Operation Dual Switch System Your hedge trimmer is equipped with a dual switch system for two-handed operation. It has a trigger switch on the rear handle as well as a front handle switch lever. It is designed so that the cutting blades will only engage if both switches are simultaneously in the depressed position. HSE 52 5