Stihl HSE 52 Product Instruction Manual - Page 9
Operating Instructions, WARNING, DANGER, After Finishing Work, MAINTENANCE, REPAIR AND, STORING
View all Stihl HSE 52 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
dust ("particulate matter"). When the inhalation of dust cannot be substantially controlled, i.e., kept at or near the ambient (background) level, the operator and any bystanders should wear a respirator approved by NIOSH/MSHA for the type of dust encountered. Operating Instructions WARNING In the event of an emergency, release one or both switches immediately to stop the movement of the cutting blades. WARNING Before you start work, examine the hedge area for stones, fence wire, metal or other solid objects which could damage the cutting blades. Take particular care when cutting hedges next to or against wire fences. Do not touch the wire with the cutting blades. When working close to the ground, make sure that no sand, grit or stones get between the cutting blades. Striking solid foreign objects such as stones, fence wire or metal could damage the cutting attachment and may cause blades to crack, chip or break. STIHL does not recommend the use of your power tool when cutting in areas where the blades could contact such objects. WARNING Observe the cutting blades at all times - do not cut any areas of the hedge that you cannot see. When cutting the top of a taller hedge, check the other side of the hedge frequently for bystanders, animals and obstructions. DANGER To reduce the risk of electrocution, never operate this power tool in the vicinity of any wires or cables (power, etc.) that may be carrying electric current. WARNING When using the electric hedge trimmer, always keep the power supply cord and extension cord behind you and away from the cutting tool. Never drape the cord over the hedge being trimmed. Always ensure that your power cords do not become entangled with obstacles or objects. Damaged cords may cause electrocution. WARNING Avoid damage to the power cords. Keep cords away from heat, oil and sharp edges. Never carry hedge trimmer by power cord or yank power cord or extension cord to disconnect the plug from the wall outlet. To unplug, grasp the plug not the cord. WARNING If the blades become clogged or stuck, always release the switches, disconnect the plug, and make sure the cutting tool has stopped, before cleaning. Debris, etc. should be cleaned off the cutting tool at regular intervals. English Check the cutting blades at regular short intervals during operation, or immediately if there is a noticeable change in cutting behavior: - Disconnect the hedge trimmer from the power supply. - Wait until the cutting blades have come to a complete standstill. - Check condition and tightness; look for cracks. - Check sharpness. - Replace damaged or dull cutting tools immediately, even if they have only superficial cracks. Do not expose to or use in rain. After Finishing Work Always clean dust and dirt off the machine - do not use any grease solvents for this purpose. Spray the blades with STIHL resin solvent. Start and run the motor briefly so that the solvent is evenly distributed. MAINTENANCE, REPAIR AND STORING This electric hedge trimmer is doubleinsulated. In such an appliance, two systems of insulation are provided instead of grounding. No grounding means are provided, nor should means for grounding be added to the appliance. Servicing a double-insulated appliance HSE 52 7