Sub-Zero 700BCI Integrated Use & Care Guide - Page 12

Integrated Use & Care 12 Storage Shelves ADJUSTABLE SHELVES Depending on the model, integrated column and tall models have adjustable tempered glass shelves or wire shelves. To remove or adjust the glass or wire shelves, first tilt the shelf up at the front, then lift it up and out of the tracks on the rear wall of the unit. Refer to the illustration below. If the door is limited to a 90° opening, you'll need to clear the door shelves in order to remove a shelf. Lift and pivot the end of the shelf nearest the door upward, and remove. To replace a shelf, insert it in the tracks at the rear of the unit with the front of the shelf raised slightly. As you push the shelf in, lower the front of the shelf until it locks into position. IMPORTANT NOTE: Always be careful in handling glass shelves to prevent breakage or scratching the interior. STATIONARY SHELF The stationary glass shelf of column and tall units, except model 736TCI, should be placed on the bottom portion of the top compartment with the beveled edge of the shelf support facing front. When installed properly, the rear support legs will space the shelf away from the back wall to ensure an even flow of air through the unit. DOOR SHELVES The door shelves and dairy compartment of column and tall models are adjustable within the guides of the door liner. The two shallow door shelves of column model IC-27R are removable, but not adjustable. To remove door shelves or the dairy compartment, lift straight up and out from the bottom as shown in the illustration. To replace, select a desired position and slide the door shelf or dairy compartment down into the guides. Shelf removal. Door shelf removal.