Sub-Zero 700BCI Integrated Use & Care Guide - Page 17
Integrated Use & Care, Lighting Information
View all Sub-Zero 700BCI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Integrated Use & Care 17 subzero.com Lighting Information CABINET LIGHTING Cabinet lighting for integrated column and tall models use standard 40-watt appliance bulbs. To replace the light bulbs, you must first remove the light shield. Place your hands under the light shield and release the two clips on the back, then lift up and slide back slowly until the key slots on the side of the light shield drop past the mounting studs in the side walls. Remove the light shield. The bulbs are now accessible. Replace the bulbs and follow the reverse steps to reposition the light shield. Refer to the illustrations below. DRAWER LIGHTING Each drawer compartment has a standard 25-watt appliance bulb recessed into the top of the compartment. Refer to the illustration below. To replace the light bulb, pull the drawer out to its full extension or remove the drawer completely. Refer to drawer removal on page 15. Replace the bulb and follow the reverse steps to reinstall the drawer. CRISPER LIGHTING (MODEL IC-27R) Crisper drawer lighting for model IC-27R is located behind the upper crisper drawer and mounted to the back wall of the refrigerator. To remove the light shield, first remove the crisper drawer. Next, remove the upper crisper shelf. Then place both hands under the bottom right and left sides of the light shield and push upward. Refer to the illustration below. LIGHT SHIELD LOCKING CLIP Cabinet lighting (column model). LIGHT SHIELD LOCKING CLIP Cabinet lighting (tall model). Shut off power to the unit at the circuit breaker before replacing light bulbs. Wear protective gloves when handling bulbs. RECESSED BULB Drawer lighting. Light shield removal (IC-27R).