Sub-Zero 700TFI Integrated Installation Guide - Page 20
Integrated Installation, Dual Installations, 90° Door Stop
View all Sub-Zero 700TFI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Integrated Installation 20 Dual Installations Two integrated units may be placed side by side in a dual installation. Panel width dimensions will vary slightly from single installations. A dual installation kit is required for installations with 2" (51) or less space between units. Dual installation kits are available through your authorized Sub-Zero dealer. IMPORTANT NOTE: If a 27" (686) unit is installed next to a 36" (914) tall model, the decorative front panels will align, however, the face frames will not. This is only apparent when both doors are open at the same time. Due to a more robust hinge on 36" (914) units, the face frame was reconfigured to maintain a consistent overall panel height. 90° Door Stop The door of integrated columns and tall models opens to 105°. A 90° door stop is built into the hinge system for installations where the door opening must be limited. To engage the door stop, use the blade edge of a standard screwdriver and rotate the cam in the center portion of the hinge. You must make this adjustment to both the bottom and top hinge. Refer to the illustration below. Typical Panel Dimensions COLUMN MODELS Door 27" (686) MODELS Door Top Drawer Bottom Drawer 36" (914) MODELS Door Top Drawer Bottom Drawer W 2613/16" (681) W 2613/16" (681) 2613/16" (681) 2613/16" (681) W 3513/16" (910) 3513/16" (910) 3513/16" (910) H 767/8" (1953) H 453/8" (1153) 139/16" (345) 1611/16" (424) H 453/8" (1153) 139/16" (345) 1611/16" (424) 90° door stop.