Sub-Zero BI-42UFD Built-In Installation Guide - Page 15
Grille Panel, Panel Installation, Side Panel - over and under with french door
View all Sub-Zero BI-42UFD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
PANEL INSTALLATION Custom Panels GRILLE PANEL Remove the bottom grille frame by extracting the lower two corner screws from each side of the grille assembly. Refer to the illustration below. With the bottom section removed, slide the custom grille panel into the frame. If the panel is thinner than 1/4" (6), a filler material will need to be installed to achieve a proper fit. Once the panel is installed, reattach the bottom grille frame by sliding the corner brackets back into position, then reinstall the four corner screws. BOTTOM GRILLE FRAME Grille frame assembly. SIDE PANEL When installing a custom side panel, an accessory kit is required and is available through an authorized Sub-Zero dealer. For local dealer information, visit the find a showroom section of our website, subzero.com. Stainless steel and white enamel side panels are also available from an authorized Sub-Zero dealer. IMPORTANT NOTE: The use of side panels may change the width of the opening. A custom side panel must be a minimum of 24" (610) deep and 1/2" (13) thick. Routing will be necessary for the side panel to fit flush against the side of the unit. Refer to the illustrations below. IMPORTANT NOTE: The height of the side panel will vary with the height of the grille. Verify the finished height before modifying panels. IMPORTANT NOTE: For over-and-under and French door models, additional routing will be necessary to accommodate the lower hinge plate of the refrigerator. 24" (610) FRONT OF SIDE PANEL 1" (25) 17/8" (48) ROUT TO 1/8" (3) 17/8"(48) 1" (25) 84" (2134) 1/8" (3) 1/2" (13) MAIN SIDE PANEL FRAME ROUTING 41/4" (108) ROUT TO 3/16" (5) (OVER-AND-UNDER MODELS) 5 3/4" (146) 201/2" (521) 4" (102) OPTIONAL TOE KICK CUT-OUT 2 5/8" (67) Side panel dimensions. Routing detail. subzero.com | 15