Sub-Zero BI-42UFD Built-In Installation Guide - Page 18

INSTALLATION Completion Reinstall the drain pan and verify it is in the proper position. Install the kickplate using screws to attach it to brackets on the inside of each roller base. Refer to the illustration below. The kickplate must be removable for service. The floor cannot interfere with removal. Refer to the label mounted on the kickplate support for height clearance. Turn power on by touching POWER on the control panel. Install the light diffuser by aligning the slots of the light diffuser onto the bracket pegs and pulling forward so the tabs on the slots engage the bracket pegs. Refer to the illustration below. WATER FILTER BYPASS If the water filtration system will not be utilized, it can be placed in water filter bypass mode by removing the water filter. Refer to the illustration below. Follow these steps to remove the water filter: 1 Pull out on the bottom edge of the grille assembly and tilt the grille frame upward. 2 To remove the cartridge, rotate the cartridge counterclockwise one-quarter turn and pull out. Refer to the illustration below. PEG SLOT Kickplate installation. Light diffuser installation. WATER FILTER WATER FILTER Location of water filter. Water filter removal. 18 | Sub-Zero Customer Care 800.222.7820