Sub-Zero BI-42UFD Built-In Use & Care Guide - Page 13

CARE RECOMMENDATIONS Cleaning INTERIOR CLEANING For over-and-under and side-by-side models, the refrigerator or freezer may be disabled without disrupting the other section. To disable a section, touch POWER. Touch and hold WARMER for the section being disabled, continue to hold and touch POWER. Double dashes will appear in the control panel display. Repeat to turn the section back on. To clean interior surfaces and all removable parts, wash with a mild solution of soap, water and baking soda. Rinse and dry thoroughly. Avoid getting water on lights and control panel. CAUTION Do not use vinegar, rubbing alcohol or other alcoholbased cleaners on any interior surface. STAINLESS STEEL EXTERIOR Use a nonabrasive stainless steel cleaner and apply with a soft lint-free cloth. To bring out the natural luster, lightly wipe surface with a water-dampened microfiber cloth followed by a dry polishing chamois. Always follow the grain of stainless steel. CONDENSER CLEANING CAUTION Before cleaning the condenser, turn power off at the control panel. Wear gloves to avoid injury from sharp condenser fins. The condenser is located behind the flip-up grille. To access, pull out on the bottom edge of the grille and rotate upward. Use a soft bristle brush and vacuum to remove dust and lint from the condenser. Clean the condenser every three to six months. Refer to the illustration below. IMPORTANT NOTE: To avoid damaging condenser fins, vacuum in the direction of the fins. CAUTION Failure to clean the condenser could result in temperature loss, mechanical failure or damage. VACATIONS For extended vacations, turn power off at the control panel. Empty the unit and block doors open slightly to let fresh air in and keep interior dry. Water filter should be replaced before start up. CONDENSER Condenser location. subzero.com | 13