Sub-Zero IT-30CIID Integrated Use & Care Guide - Page 11
Water Filtration System
View all Sub-Zero IT-30CIID manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
OPERATION Water Filtration System The water filtration system of Sub-Zero integrated models supplies filtered water to the ice maker and water dispenser (dispenser models) to produce great-tasting water and ice. IMPORTANT NOTE: When using the water filtration system for the first time and after filter replacement, it is necessary to clear any air from the system and allow the filter to assist in cleaning the water lines. For non-dispenser models, discard the first two full containers of ice. For dispenser models, dispense several glasses of water for a period of two minutes. If the water filtration system will not be utilized, it can be placed in water filter bypass mode by removing the filter. The filter is rated for 750 gallons (2839 L) or one year, whichever comes first. 'Change Water Filter' will appear on the control panel when the cartridge needs to be replaced. Touch 'Snooze' to delay reminder for 24 hours or until filter can be replaced. Replacement Sub-Zero water filters can be ordered online at subzerowolfstore.com. For questions, contact Sub-Zero customer care at 800-222-7820. WATER FILTER REPLACEMENT 1 To access the water filter, pull out on the bottom edge of the access door and rotate upward. Refer to the illustration below. 2 To remove the old filter, rotate counterclockwise onequarter turn, then pull out. It is normal for a small amount of water to drip when the filter is removed. It should be wiped up with a paper towel or cloth. 3 Remove the new filter from packaging and remove plastic cap. 4 Insert the new filter into the manifold and turn clockwise. 5 Once the new filter has been installed, follow instructions on the control panel. The filter life cycle will reset for approximately one year. ACCESS DOOR WATER FILTER Water filter removal. subzero.com | 11