Sub-Zero PRO 48 with Glass Door PRO 48 Installation Guide - Page 3
PRO 48 Refrigeration, Sub-Zero PRO 48 Refrigeration, Before You Start - refrigerator freezer
View all Sub-Zero PRO 48 with Glass Door manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
PRO 48 Refrigeration 3 subzero.com/specs Sub-Zero PRO 48 Refrigeration The importance of the installation of the Sub-Zero PRO 48 unit cannot be overemphasized. Installation should be done by a qualified installer. Before you begin the installation process, it is recommended that you read this entire installation guide. There are key details that you should take special care to observe during the installation. By reading these instructions carefully, you will make the installation process easier, problem-free and most importantly, safe. The installation process is identical for both the model 648PROG which features a glass door on the upper refrigerator compartment and model 648PRO with a solid door. Any questions or problems regarding the installation should be directed to your authorized Sub-Zero dealer or Sub-Zero customer care at 800-222-7820. You may also check the contact & support section of our website, subzero.com. Important product information, including the model and serial number of your unit are listed on the product rating plate. The rating plate is located on the left side of the top freezer drawer compartment (drawer must be open). Refer to the illustration below. Before You Start Make sure the opening dimensions, door and drawer clearances, electrical service and plumbing are correct for the model you are about to install. Refer to specifications on the following pages. TOOLS AND MATERIALS REQUIRED • Appliance dolly able to support 1000 lbs (454 kg) and adequate manpower to handle the weight of the unit. • Phillips and slotted screwdrivers. • Torx drive screwdriver set • Allen, standard and crescent wrenches. • Various sized pliers. • 7/16" hex bolt nut driver. • Cordless drill and assorted drill bits. • Level-2' (.6 m) and 4' (1.2 m) recommended. • 4' (1.2 m) of 1/4" copper, braided stainless steel or PEX tubing and saddle valve for water line (do not use self-piercing valves). • Tubing cutter. • Masonite, plywood, pressed fiberboard, cardboard or other suitable material to protect finished flooring. • Appropriate materials to cover and protect the home and furnishings during installation. RATING PLATE Location of rating plate (open drawer).