Symphonic SC3913V Owner's Manual - Page 11

CABLE WITH CONVERTER/ DESCRAMBLER BOX OR SATELLITE BOX If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown here. By using this connection you can also record scrambled channels. However, channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TVNCR Remote Control. Unattended timer recording is limited to one channel at a time. INSTALLING THE' BATTERIES 1) Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow. 2) Insert 2 "AA" penlight batteries into the battery compartment in the direction indicated by the polarity (+/-) markings. 3) Replace the cover. r 0 0 Satellite Box or OUT Cable Box (Not supplied) IN From Cable System or Satellite Dish 75-ohm Coaxial Cable (Not supplied) ANT. NM I O 0 [Fig.7] ° EXTERNAL INPUT MODE When using an external input signal (another VCR or video camera), connect the player's audio/video output cables to the AUDIO IN/ VIDEO IN jacks of your TVNCR. Then press the CHANNEL A or V button until "AUX" appears on the screen. AUX TO RECORD A SCRAMBLED/UNSCRAMBLED CHANNEL 1. Set the TVNCR channel selector to the output channel of the Cable Converter Box or Satellite Box. (Ex. CH3) 2. Select the channel to record from your Cable Converter Box or Satellite Box. EN 9F07