Symphonic SC3913V Owner's Manual - Page 25
Source Playing
View all Symphonic SC3913V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
OTR (One Touch Recording) This function enables you to set a recording length simply by pressing the REC/OTR button on the TVNCR. Make sure ... • TVNCR power must be turned on. • Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.) NOTES: • This function CANNOT be done from the remote control. • Recording starts immediately when the REC/OTR button is pressed. • When the REC/OTR button is pressed 18 times, the TV/VCR returns to the Normal Recording mode. • To stop the OTR operation, press the STOP button on the TVNCR or on the remote control. • To show the remaining time, press the DISPLAY button on the remote control so that "OTR" appears on the TV screen. (It will show up momentarily then disappear.) • Recording stops when 0:00 is reached. • Please note that in the SLP mode maximum recording time, assuming the tape is started at the beginning, is 8 hours using T-160 (or 6 hours using T-120). • If the tape runs out before the end time, the TVNCR will switch to the Stop mode immediately, ejects the tape and turns itself off. Push(es) 1 push 2 pushes 3 pushes 1 17 pushes Display Recording length (normal recording) 0:30 30 minutes 1:00 60 minutes 1 1 8:00 480 minutes COPYING A VIDEO CASSETTE (Re wires a VCR or camcorder) You can make copies of video tapes made by friends or relatives for your enjoyment. WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws. Connect your TVNCR and a Source (Playing) VCR using the following diagram. [Fig.8] EMI 0 [The TVNCR] [Ex: Source (Playing) VCR or camcorder] Select the channel to be recorded Press the number buttons on the remote control or the CHANNEL V or A button. Remember: If the TV/VCR is connected to a cable box or satellite box, the TVNCR must be on CH3 or CH4, then the channel to be recorded is selected on the cable box or satellite box. 2 Select the tape speed Press the SPEED button to select the desired tape speed (SP/SLP). 3 Begin 0TR OTA(2,30) Press the REC/OTR button on the TV/VCR as many times as needed. The recording length will be determined by the num ber of times you press the REC/OTR button. Each additional push will increase the recording time by 30 minutes. It is set up to 8 hours. AudioNideo adapter cable (not supplied) VIDEO OUV AUDID 1) Insert a pre-recorded video cassette into the Source (Playing) VCR or camcorder. 2) Insert a blank video cassette, or one you want to record over, into the TVNCR's cassette compartment. 3) Press the SPEED button on remote control for the TV/VCR to select the desired recording speed (SP/SLP). 4) Press the CHANNEL A or V button on the TV/VCR until "AUX" appears on the screen. 5) Press the RECORD button on the TVNCR. 6) Begin playback of the tape in the source (Playing) VCR or camcorder. NOTE: For best results during dubbing, use the TVNCR's front panel controls whenever possible. The remote control might affect the source (Playing) VCR's playback operation. - 25 - EN 8H30