Symphonic SC724DF Owner's Manual - Page 18

Recording

Page 18 highlights

TV/VCR SECTION RECORDING NOTES: • Insert a cassette tape with its erase-prevention tab in place. • This unit cannot record the contents from the built-in DVD. • You can ONLY watch the same TV program that is being recorded. NORMAL RECORDING 1 Use [CH. K / L] or the Number buttons to select the channel to be recorded. TV/VCR CH 10 NOTE: • If the unit is connected to a cable box or satellite box, the unit must be on CH3 or CH4. Select the channel to be recorded on the cable box or satellite box. 2 Press [SPEED] to select the desired tape speed (SP/ SLP). (Refer to "SELECTING TAPE SP SPEEDS" on page 15.) 3 Press [REC] to start recording. REC SP 4 Press [PAUSE F] to tempo- PAUSE rarily stop recording unwanted scenes. Press [PAUSE F] again or [REC] to resume recording. SP NOTE: • If the recording is paused for more than 5 minutes, the unit will automatically switch to the recording mode to prevent tape damage. 5 Press [STOP C] to stop recording. OTR (One Touch Recording) TV/VCR This function enables you to start record- ing for specified length simply by pressing [REC/OTR] on the unit. 1 Use [CH. K / L] or the Number buttons to select the channel to be recorded. NOTE: • If the unit is connected to a cable box or satellite box, the unit must be on CH3 or CH4. Select the channel to be recorded on the cable box or satellite box. 2 Press [SPEED] to select the desired tape speed (SP/SLP). (Refer to "SELECTING TAPE SPEEDS" on page 15.) 3 Press [REC/OTR] on the unit OTR (2 : 30) repeatedly until your desired length appears on the screen. The recording time will increase by 30 minutes up to 8 hours. SP Recording starts immediately when you press [REC/OTR]. NOTE: • If you press [REC/OTR] when "8:00" is displayed, the unit returns to the normal recording mode. Time(s) 1 time 2 times 3 times ↓ 17 times Display Recording length (normal recording) 0:30 30 minutes 1:00 60 minutes ↓ ↓ 8:00 480 minutes NOTES: • Even if you press [POWER] during OTR, the unit continues recording. • You cannot start OTR with the remote control. • In the SLP mode, maximum recording time, assuming the tape starts at the beginning, is 8 hours using T-160 (or 6 hours using T-120). • If the tape runs out before the end time, the unit will switch to the stop mode immediately, eject the tape and turn itself off. • To show the remaining time of OTR, press [DISPLAY] on the remote control to display "OTR" on the TV screen. (It will show up momentarily then disappear.) TO CANCEL OTR IN PROGRESS Press [STOP/EJECT CA] on the unit or [STOP C]. 18 EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

EN
18
R
ECORDING
NOTES:
• Insert a cassette tape with its erase-prevention tab in place.
• This unit cannot record the contents from the built-in DVD.
• You can ONL
Y
watch the same TV program that is being
recorded.
NORMAL RECORDING
TV/VCR
TV/VCR
SP
1
Use
[CH.
K
/
L
]
or
the Number
buttons
to select the channel to
be recorded.
NOTE:
• If the unit is connected to a cable box or satellite
box, the unit must be on CH3 or CH4. Select the
channel to be recorded on the cable box or satellite
box.
2
Press
[SPEED]
to select the
desired tape speed (SP/ SLP).
(Refer to "SELECTING TAPE
SPEEDS" on page 15.)
3
Press
[REC]
to start recording.
4
Press
[PAUSE
F
]
to tempo-
rarily stop recording unwanted
scenes.
Press
[PAUSE
F
]
again or
[REC]
to resume recording.
NOTE:
• If the recording is paused for more than 5 minutes,
the unit will automatically switch to the recording
mode to prevent tape damage.
5
Press
[STOP
C
]
to stop recording.
OTR (One Touch Recording)
TV/VCR
TV/VCR
This function enables you to start record-
ing for specified length simply by press-
ing
[REC/OTR]
on the unit.
1
Use
[CH.
K
/
L
]
or
the Number buttons
to
select the channel to be recorded.
NOTE:
• If the unit is connected to a cable box or satellite
box, the unit must be on CH3 or CH4. Select the
channel to be recorded on the cable box or satellite
box.
2
Press
[SPEED]
to select the desired tape speed
(SP/SLP).
(Refer to "SELECTING TAPE SPEEDS" on page 15.)
3
Press
[REC/OTR]
on the unit
repeatedly until your desired
length appears on the screen.
The recording time will increase
by 30 minutes up to 8 hours.
Recording starts immediately when you press
[REC/OTR]
.
NOTE:
• If you press
[REC/OTR]
when "8:00" is displayed,
the unit returns to the normal recording mode.
NOTES:
• Even if you press
[POWER]
during OTR, the unit
continues recording.
• You
cannot
start OTR with the remote control.
• In the SLP mode, maximum recording time, assum-
ing the tape starts at the beginning, is 8 hours using
T-160 (or 6 hours using T-120).
• If the tape runs out before the end time, the unit will
switch to the stop mode immediately, eject the tape
and turn itself off.
•To show the remaining time of OTR, press
[DISPLAY]
on the remote control to display "OTR" on the TV
screen. (It will show up momentarily then disappear.)
TO CANCEL OTR IN PROGRESS
Press
[STOP/EJECT
C A
]
on the unit or
[STOP
C
]
.
Time(s)
Display
Recording length
1 time
(normal recording)
2 times
0:30
30 minutes
3 times
1:00
60 minutes
17 times
8:00
480 minutes
CH 10
REC
SP
PAUSE
SP
OTR (2 : 30)
SP
TV/VCR SECTION